How to undertake cork flooring installation

← Homepage

Corking flooring installation is a simple process that you can do for your own. However, before you embark on the same, you need to have adequate knowledge to go about it. Some of the tips that will make your cork flooring to be an easy one for you are outlined below

Corking flooring installation is a simple process that you can do for your own. However, before you embark on the same, you need to have adequate knowledge to go about it. Some of the tips that will make your cork flooring to bean easy one for you are outlined below.

To begin with, you need to have the room in which you want to undertake the activity well prepared. This will be done by the removal of the pieces of furniture or any other appliances that are in the room. After you are through with that, you will have to score those joints found between the wall and the top part of the baseboard. You can use the knife to make it faster or any other devices that you can access to cut through the paint or any caulking. This will allow you to have the baseboard removed using a pry bar. While you will be levering the baseboard from the wall, use a thin piece of lumber to have it protected. As you do so, ensure that you handle them carefully in order for them to be reusable if there will be the need to do so.

Try to test whether the tiles are able to fit. This should begin with the laying of the floor from that side that is the longest and as you head to the rows. This helps in avoiding cases of having small pieces placed at the end of the floor. Nevertheless, if it happens, cut one of the tiles in two halves and have it laid on the longest side of the wall so that you try to find out whether you can a larger piece at the end.

The next thing will be cutting of the door casings. You will have to place a piece of tile near the doorjamb in order to establish the best height that you can have the jamb saw set. Get the castings cut and then with the use of the screwdriver, you can proceed to have pieces pried out. The next step will be marking of the tiles that you will do by sliding the particular tile below the casting and then mark the points as required. With the help of the speed square, you will extend the lines to make it easier for you to cut them using the jigsaw.

When you have done the best to get the cork flooring tiles, the only thing that you will be left to do is to have them installed. At this point, you need to be very cautious so that you do not ruin your entire effort made before. Begin by getting the first tilelaid in the best way possible. The next tiles will just fit on the tile that you have laid. Once you get the first right, the process will repeat itself until you are through with the task. As you will be arranging the tiles, you should not forget to snug them together using the tapping block.